Microcell Materials

1/4"	(6.35)	3/4"	(19.05)
3/8"	(9.52)	1"	(25.40)
1/2"	(12.70)

1/4"	(6.35)				3/8"	(9.52)
5/16"	(7.93)

1/4"	(6.35)	9/16"	(14.28)
5/16"	(7.93)	5/8"	(15.78)
3/8"	(9.52)	3/4"	(19.05)
7/16"	(11.11)	1"	(25.40)
1/2"	(12.70)

1/4"	(6.35)				3/4"	(19.05)
3/8"	(9.52)				1"	(25.40)

1/16"	(1.58)	.36"	(9.00)
1/8"	(3.17)	3/8"	(9.52)
3/16"	(4.76)	7/16"	(11.11)
.24	(6.00)	1/2"	(12.70)
1/4"	(6.35)	9/16"	(14.28)
5/16"	(7.93)	5/8"	(15.85)
.32	(8.00)	3/4"	(19.00)

Material Descriptions

Green G'rilla™

A real powerful, tight tolerance, highly resilient ejector. Particularly well suited for both flat bed and rotary die cutting. Flat Bed: Scrap ejection for both corrugated and solid fiber substrates. Excellent for use in slots. The Groovy G'rilla cut does a great job of ejecting material from slots as narrow as 1/8' wide. Rotary: the combination of resilience and firmness makes this ejector the perfect for interior scrap and lead and side trim ejection. In addition, Green G'rilla is well known for its extreme durability.

Red Rhino

A real prime mover. This new polymer ejector has a very wide compression range. And because of it's ejection force at small compression amounts, it is excellent for thin as well as thick substrates. For example, use it ~ between .001 and .200 thick substrates when using a .375' thick ejector with .063' surplus over knife height Excellent for folding carton as well~as for corrugated diecutting. It is a very economical, tight tolerance, ejector that is recommended for both hand fed and machine fed flat diecutting as well as rotary diecutting.

Super Strip

A European, high ejection force, product used mainly for slot ejection in both rotary and flat-bed diecutting. Because of the overpowering nature of this product, it should be used very sparingly. It's best to use small pieces or strips so that it doesn't inhibit diecutting in areas of use. Prudent care IS needed so as not to overload the press as well. This material also tends to darken in color from exposure to light.

Groovy G'rilla™

A hard-to-beat, excellent ejector with very rapid recovery. It is also very economical. Recommended for thick substrates. Because of it's economy, it is attractive for hand fed flat bed diecutting. Because of it's resiliency, it is a great ejector for machine fed flat bed and rotary diecutting. It's resistance to abrasion makes it an excellent ejector for cutting abrasive products.

BK-85

A high density, super-resilient ejector that packs a lot of wallop. Use in both rotary and flat-bed diecutting for that extra push needed in slots or tightly ruled areas of the die. It's also good as a trim breaker rubber. Very stable. Tight tolerance. Available in the Zig Zag (Groovy G'rilla) cut as well.